The fact of the matter, is that in this day, and age electricity and gas are just too costly to allow to go to waste. So just keep on reading because by the time you reach the bottom of the page you’ll have three energy saving tips that you can put to use to help you trim some fat off your power bills.

The problem for far too many people, and you may be one of them, is that they focus on the big things while smaller energy waste issues bleed them out financially over the long run. Of course the bigger ticket items need tending to as well but smaller issues take less money, and can be remedied now.

Number one of your energy saving tips is to go and take a good look under any exterior doors that you have on your home or business. Now that slim area of space may seem marginal, but if you have a few outside doors, the combined space can add up to the same thing as leaving a small window in your home open for 24 hours a day.

All exterior doors are supposed to have brushes under them, but they can wear out, or fall off. Fortunately they’re inexpensive and easy to replace. Your first task is to tap the center pins out of the door hinges using a hammer, and flat screwdriver then lift the door away. After that it’s simply a matter of screwing the new door brushes in place on the bottom end.

The second of your energy saving tips, is to install tight fitting blinds on all your windows to block out the suns rays, and keep warm air in during the winter months. Also just like the door brushes, this is a relatively simple task, and the materials are cheap too. Or; if you want to spend a little more money then consider new insulated window blinds.

Go take a look at your window curtains because if they’re made from thin fabric, you may want to change them out to something more thicker that can help to insulate. Then again, another hot tip is to consider having your windows tinted because this is a good sun-blocker. Tinting is cheap, and it only takes minutes.

Tip #3: Take a little time to make sure your heating and air conditioning unit or units are in prime working order, and you can start with the outside. Go outside and check to be sure that the heat exchange grates aren’t clogged, or obstructed with leaves, cobwebs, or general debris.

Far too many people don’t realize it but the interior aluminum grills on AC units also have to be cleaned from time to time, and this especially holds true if you’ve been lax on changing your filters. Remove the screws and place them in a cup, so they don’t get lost then pull the buildup off the surface with a brush.

Looking to find the best deal on renewable energy jobs, then visit www.123gogreen.co.uk to find the best advice on solar panels for you.